CAV® 4.2 Operator's Manual, Rev. 2.0
27
CANNON® Connecting with VISCPRO II
The following registry keys are set to default values during installation of VISCPRO. You
cannot edit them from within the VISCPRO software. The only way to change these values is
by directly editing the registry.
Caution: Editing registry entries may be hazardous to the health of
your Windows® installation.
Table 17 — VISCPRO II registry entries
TCP port on which VISCPRO listens
IP address of the Ethernet connection
that VISCPRO uses
Maximum number of instrument to
which VISCPRO will connect. VISCPRO
polls for instruments in sequential order
of the InstrumentAddress. Once the
maximum number of allowed instrument
has been reached, it stops polling.
(2 seconds)
Maximum time in milliseconds that
VISCPRO waits for an instrument
response when polling.
(20 seconds)
Maximum time in milliseconds that
VISCPRO waits for an instrument
response.
To Next Page
