Cannon CAV 4.2 - Specifications

CAV® 4.2 Operator's Manual, Rev. 2.0
55
CANNON® Advanced Setup
Table 26 — Method Settings: Advanced
Setting
Description
Maximum Bulb 1 Fill Time
Maximum time (sec) to fill bulb 1
Minimum Bulb 1 Select Time
Time (1/10 sec) used to determine whether the sample will
run in bulb 1 or 2. Bulb 1 will be selected if the efflux exceeds
this time
Minimum Bulb 2 Fill Time
Maximum time (sec) to fill bulb 2
Maximum Bulb Empty Time
Maximum time (sec) for the sample to drop between the
target sensor and the bottom sensor
Tube Empty Time
Percentage of the bulb 1 efflux time that is used to empty
the tube after the bottom sensor becomes uncovered
Bulb 1 Overdraw Time
Time (sec) that the sample is pulled past the target sensor
during a bulb 1 sample fill
Bulb 2 Overdraw Time
Time (sec) that the sample is pulled past the target sensor
during a bulb 2 sample fill
Bulb 3 Overdraw Time
Time (sec) that the sample is pulled past the target sensor
during a bulb 3 sample fill
Sample Draw Delay
Time (sec) after the sample cup is raised before sample is
drawn into the tube
Bulb 1 Vent Drain Time
Time (sec) for a bulb 1 sample between when the tube vent
is opened to atmosphere and the sample efflux starts
Bulb 2 Vent Drain Time
Time (sec) for a bulb 2 sample between when the tube vent
is opened to atmosphere and the sample efflux starts
Bulb 3 Vent Drain Time
Time (sec) for a bulb 2 sample between when the tube vent
is opened to atmosphere and the sample efflux starts