Cannon CAV 4.2 - Adjust solvent dosing chamber sensors

CAV® 4.2 Operator's Manual, Rev. 2.0
54
Advanced Setup CANNON®
Table 25 — Method Settings: Wash
Setting
Description
Bulb1 Solvent A Washes
Number of solvent A washes for samples run in only bulb 1
Bulb1 Solvent B Washes
Number of solvent B washes for samples run in only bulb 1
Bulb1 Solvent C Washes
Number of solvent C washes for samples run in only bulb 1
Bulb2 Solvent A Washes
Number of solvent A washes for samples run in bulbs 1/2
Bulb2 Solvent B Washes
Number of solvent B washes for samples run in bulbs 1/2
Bulb2 Solvent C Washes
Number of solvent C washes for samples run in bulbs 1/2
Bulb3 Solvent A Washes
Number of solvent A washes for samples run in bulbs 1/2/3
Bulb3 Solvent B Washes
Number of solvent B washes for samples run in bulbs 1/2/3
Bulb3 Solvent C Washes
Number of solvent C washes for samples run in bulbs 1/2/3
Maximum Solvent A Fill Time
Max time (sec) to fill the solvent bulb with solvent A
Maximum Solvent B Fill Time
Max time (sec) to fill the solvent bulb with solvent B
Maximum Solvent C Fill Time
Max time (sec) to fill the solvent bulb with solvent C
Solvent A Injection Time
Time (sec) that solvent A will be injected after bulb empties
Solvent B Injection Time
Time (sec) that solvent B will be injected after bulb empties
Solvent C Injection Time
Time (sec) that solvent C will be injected after bulb empties
Cup Empty Time
Time (sec) to empty cup of sample at start of wash cycle
Tube Tip Soak Time
Time (sec) for tip to soak after solvent injection
Solvent Evacuation Time
Time(sec) to empty cup of solvent after soaking
Final Air Dry Time
Time(sec) to force air dry A-Pipe at end of wash cycle
Wash B-Pipe
Specify if B-Pipe should be washed
B-Pipe Solvent A Washes
Number of solvent A washes for B-Pipe
B-Pipe Solvent B Washes
Number of solvent B washes for B-Pipe
B-Pipe Solvent C Washes
Number of solvent C washes for B-Pipe
B-Pipe Dry Time
Time(sec) to force air dry B-Pipe