Cannon CAV 4.2 - Page 68

CAV® 4.2 Operator's Manual, Rev. 2.0
58
Advanced Setup CANNON®
Table 28 — CAV data table fields
Setting
Description
Method Name
Name of the method used to run the sample
KV
Average kinematic viscosity of the sample
% KE
% contribution of the kinetic energy correction to the measured
viscosity
Known KV
Value entered for the known KV of the sample
% Diff KV
% difference between the measured KV and the known KV
Temp
Average bath temperature
T1-T4
Times for the valid effluxes used in the calculations
% Diff
(Max efflux time – Min efflux time) / average efflux time
Abs. Diff
Max efflux time – Min efflux time
{1,10} Efflux %d
Adds the first 10 efflux times to the analysis
{1,20} Efflux %d
Adds the first 20 efflux times to the analysis
Avg Efflux
Average efflux time calculated using valid effluxes
C
C constant of calibration
E
E constant of calibration
SUS
Saybolt Furol Seconds calculation
Display Kinematic
Viscosity Data
Check to display samples not run with Verify Known KV method
Display KV Check Data
Check to display sample run with Verify Known KV method
Max KV % Difference
When the % Diff KV exceeds this value, an "X" is displayed in the
TOL column
8. Click OK. You will be prompted to save the analysis.
• If you choose YES, the analysis will be displayed after it is saved.
• If you choose NO, the analysis will still be displayed.