Canon Canovision8 E50E - Page 147

3-10 S Reel Table, T Reel Table
* Disassembling (Fig.II-17)
(1) In the same procedures in "3-4", dismount the § and 7 brake.
(2) In the same procedures in "3-5", detach the TL Plate.
(3)
In
the
same
procedures
in
"3-11",
take
off
the
tension
regulator
band.
3
(4)
Dismount
the
$
reel
table
@.
i
(5)
Turn
the
stopper
@
in
the
direction
of
@
by
90°
approximately.
i
(6)
While
shifting
the
LB
releasing
arm
©
in
the
direction
of
®,
dismount
the
T reel table. :
a See
*Reassembling (Fig.II-17)
*Caution:
When
mounting
$
and
T
reel
tables,
be
careful
not
to
drop
the
oil
=;
,
onto
the
reflection
plate
at
the
rear
side.
If
the
oil
dropped,
dust
particles
may
put
on
and
it
makes
the
counter
inaccurate.
(1) Apply the 1/2 drop of oil to the shaft ©. (Fig.A)
(2) Rotate RK gear © to the direction of ©.
Rotate the TS brake @ to the direction of ©.
(3) While shifting the LB releasing arm @ to the direction of ©, mount the T
reel table @ to the shaft ©.
“Then,
turn
the
stopper
@
to
the
direction
of
®
until
it
comes
to
an
end.
(4) Apply the 1/2 drop of oil to the shaft @. (Fig.B)
(5) Rotate the RK gear © to the direction of ®.
Rotate the UL brake to the direction of @.
Rotate the LB brake to the direction of @.
(6) Mount the S$ reel table to the shaft ©. -
(7) In the same procedures in "3-11", hook up the tension regulator band.
(8) In the same procedures in "3-5", attach the TL plate.
(9) In the same procedures in "3-4", mount the S brake and T brake.
very,
re
@s reel table a
oa @uu brake
i
@T reel table
Fig.A Fig.B
@ stopper
—-@Ts brake i
Fig.II-17 e
ate
@tL8 brake
@LB releasing arm