5. Eye-Control AI Servo AF Mode
48
1
2
3
4
5
6
Set the < > switch to < >.
Turn the < > dial to select a
CAL No.
• If the calibration has been completed, the
CAL No. will be displayed. If there is no
calibration, the CAL No. will blink.
Set the < > switch to < >.
Select the shooting mode.
Look at where you want to focus
within the area AF ellipse, then
press the shutter button halfway.
• The corresponding focusing point, select-
ed by eye, lights and achieves focus. This
focusing point will continue to focus the
subject.
Take the picture.
• The initial focusing point you select by eye remains active during continuous
focusing in the AI-Servo AF mode. You cannot select another focusing point by
eye during continuous focusing (while the shutter button is pressed halfway).
• If a focusing point cannot be selected by eye, the camera switches to automatic
focusing point selection. See page 38.
04. C836-E (33~) 28-01-2003 11:11 Pagina 48
To Next Page
Loading...
