Loading a Roll
Important
•
Be careful not to soil the printing s urface of roll pap er as y
ou pull it out. This may
affect the pr inting quality.
•
If the paper is wrinkled or warped, straighten it out before loading it.
•
If it is difficult to i nsert the roll paper in the Paper Feed Slot, insert the left or right
corner in the slot first, and then straighten the paper as you advance it.
•
Load the roll so that there is no gap between the right edge of the paper and the
Roll Holder.
Note
•
You can adjust the strength of vacuum holding paper against the Platen when the
Release Lever is open. If it is difficult to load paper, press the ▲ or ▼ button on
the Control Panel to adjust the strength. Set vacuum stronger by pressing the ▲
button or weaker with the ▼ button. Three settings are available.
8
Pull the roll edge gently and align it with the Paper Alignment Line (a). Lower the
Release Lever toward the front.
16
To Next Page
