Responding to Messages
49
Cannot feed paper. The paper has come out of the
printer.
Remove the paper, press the Load/
Eject button, and reload the paper.
Hold down the Stop button for a
second or more to cancel printing.
Error Messages Cause
Corrective Action
A paper jam has occurred. Lift the Release Lever, remove the
jammed paper, and reload paper.
If the error occurs again, turn off
the printer and wait a while before
restoring power.
End of paper feed. You are pressing the ▲ button
on the Control Panel and
trying to rewind the roll to the
edge.
Release the ▲ button.
Insufcient paper for job The printer has received a print
job longer than the amount of
roll paper left.
Follow the steps below to replace the
roll.
1.
2.
Remove the roll.
Load a roll with enough paper left.
(→P.11)
(→"Removing the Roll from the
Printer," User Manual)
(→"Specifying the Paper Length
(Roll)," User Manual)
(→"Removing a Roll from the Roll
Holder," User Manual)
3.If no barcode was printed on the
roll, specify the paper type.
4.
Specify the paper length, unless a
barcode has been printed on the
roll and you have deactivated the
automatic detection function of the
remaining roll paper.
(→"Selecting the Paper Type
(Roll)," User Manual)
Press the Online button to resume
printing.
However, the roll paper will run out
during the print job, and you will not
be able to print all of the document.
To Next Page
Loading...
