Canon LBP7660Cdn - Setup] Menu ([User Maintenance] Options)

0258-08Y
NOTE
Table description
Bold values in the table indicate the default settings.
The setting items or setting values with "*" may not be displayed depending on the availability of the optional
accessories and other settings.
Setting Item Setting Value Setting
[Adj. Start Position]
[Offset Y
(MP Tray)]:
-5.0 to 0.0
to +5.0
(mm)
[Offset X
(MP Tray)]:
-5.0 to 0.0
to +5.0
(mm)
[Offset Y
(Drawer 1)]:
-5.0 to 0.0
to +5.0
(mm)
[Offset X
(Drawer 1)]:
-5.0 to 0.0
to +5.0
(mm)
[Offset Y
(Drawer
2)]
*
: -5.0 to
0.0 to +5.0
(mm)
[Offset X
(Drawer
2)]
*
: -5.0 to
0.0 to +5.0
(mm)
[Offset Y
(2-Sided)]:
-5.0 to 0.0
to +5.0
(mm)
[Offset X
(2-Sided)]:
-5.0 to 0.0
to +5.0
(mm)
Specifies the printing position of the paper in the specified paper source.
Adjusts the position in the vertical direction (Y) or the horizontal direction
(X) by the specified value.
The setting values are indicated in millimeters (mm), and you can adjust
the position using [
] and [ ].
If you do not adjust the printing position, specify [0.0] for this item.
Adjust the printing position for 2-sided printing as follows.
Adjust the printing position of the first page using [Offset Y (2-Sided)]
and [Offset X (2-Sided)].
The printing position of the second page depends on the settings for
each paper source.
"Adjusting the Printing Position for Each Paper Source"
[Recovery Printing] [Off], [On]
Specifies whether to print the partially printed page when the printer stops
printing due to a paper jam or an error occurring.
[Check Paper Size] [Off], [On]
Specifies whether the printer should stop printing, displaying the message
<Check paper size.> or continue printing when [MP Tray Paper Size],
[Drawer 1 Size], [Drawer 2 Size] is set to [Mixed Sizes].
[Setup] Menu ([User Maintenance] Options)
㻡㻥㻢㻌㻛㻌㻥㻥㻤