104
Transition Effects
You can select the transition effect used when one image is
replaced by another.
3
Select [Start] and press .
z The following functions are available
during slide shows.
- Pausing/resuming the slide show:
press the FUNC./SET button
- Fast forwarding/rewinding the slide
show: press the or button
(continue to hold the button to switch between images
more rapidly)
- Stopping the slide show: press the MENU button.
No transition effect.
The new image gradually brightens as it moves upward from the bottom.
The new image first appears in a cross shape and gradually
expands to display the full image.
Portions of the new image move horizontally, then the image
expands to display the full image.
In single image playback mode, you can start a slide show
from the current image displayed by holding the FUNC./SET
button while you press the button. Please note that if
you do this while the last image shot is displayed, the slide
show will start from the first image using the same date.
Select a date/category/folder to play
back ( / / )
1
Select , or and press .
To Next Page
Loading...
Need help?
General
