52
You can check the difference between the selected exposure and
the standard exposure*. If the difference is more than ±2 stops,
the selected exposure appears in red on the LCD monitor. In
addition, when you press the shutter button halfway, the
difference between the standard exposure* and the selected
exposure appears on the LCD monitor. If the difference is more
than ±2 stops, “–2” or “+2” appears in red.
* Standard exposure levels are calculated by measuring light according to
the currently selected metering mode.
Stitch Assist can be used to shoot overlapping images that can later
be merged (stitched) to create one panoramic image on a
computer.
z If the zoom is adjusted after these values are set, the
aperture value may change in accordance with the zoom
position (p. 49).
z The LCD monitor’s brightness matches the selected shutter
speed and aperture value.
When you select a fast shutter speed or shoot a subject in a
dark place, the image will always be bright if the flash is set
to (Flash on) or if an external flash is attached.
Shooting Panoramic Images
(Stitch Assist)
Shooting Mode
The overlapping seams of
several adjacent images
can be joined into a single
panoramic image.
To Next Page
Loading...
Need help?
General
