147
Appendix
High-Power Flash HF-DC1
This flash is used to supplement the camera’s built-in flash when
the subject is too far away for proper illumination. Use the following
procedures to affix the camera and High-Power Flash to the
supporting bracket.
Please read the instructions accompanying the flash along with this
explanation.
z The High-Power Flash will not fire under the following
circumstances.
- When shooting in mode
- When [Flash Sync] is on [2nd-curtain]
- When [Flash Adjust] is on [Manual]
z The flash charge time will lengthen as the battery charge
gets weaker. Always set the power/mode switch to [OFF]
when you finish using the flash.
z Be careful not to touch the flash window or sensor
windows with your fingers while the flash is in use.
z The flash may fire if another flash is being used in close
proximity.
z The High-Power Flash may not fire outdoors in daylight or
when there are no reflective items.
Tripod
Sockets
Bracket
(Comes with the flash)
To Next Page
Loading...
