13
Installing and Removing the Battery
Introduction
The remaining battery power is displayed when the camera is turned on.
Number of images that can be transferred Approx. number of images
Using a fully charged LP-E6. The number of images that can be transferred is nearly the
same at normal temperature (23°C / 73°F) and low temperature (0°C / 32°F).
When automatic transfer is performed during shooting of an image of approx. 6.1 MB under
conditions based on the CIPA (Camera & Imaging Products Association) test standards.
Fewer images can be transferred when transferring images over a wireless LAN.
Fewer images can be transferred when using bus-power external media or GPS devices.
1
Open the cover.
Slide the lever to open the cover.
2
Remove the battery.
Press the battery lock lever in the direction of the
arrow to unlock, and then unload the battery.
To prevent a short-circuit, be sure to always attach
the protective cover to the battery.
Battery check
Icon Level (%) Status
100 - 70 Sufficient battery level
69 - 50 Battery level exceeds 50%
49 - 20 Battery level below 50%
19 - 10 Battery level is low
9 - 1 Battery will be exhausted soon
0 Recharge the battery
LAN At Normal Temperature (23°C / 73°F) At Low Temperature (0°C / 32°F)
Wireless LAN 2100 2100
Wired LAN 2400 2400
Removing the battery
To Next Page
Loading...
