5310M-0707-040-E
2. Remove the ignition plug with a plug wrench.
3. Check for the following defects, or damage.
Replace plug if damaged or cannot be
cleaned.
* Damage to insulator
* Worn electrodes
* Carbon deposits on electrodes
* Damage or breakage of gasket
* Burned insulator
Cleaning Ignition Plug
1. Clean the ignition plugs with a wire brush and
plug cleaner.
2. Adjust the electrode (spark) clearance with
sandpaper, to keep the following clearance:
3. Install the ignition plug.
4. Attach the ignition plug cap.
Standard clearance: 0.75 mm
5310M-0707-050-E
* Plug model number: See page 15
NOTE
To Next Page
Loading...
