CanyCom CM 230 - How to Perform Work; Checking Cutting Blades; Adjusting Blade Height

-37-
Operation 6
How to Perform Work
Adjusting Blade Height
1. Adjust cutting height with the blade height
adjusting switch.
2. Confirm the cutting height through the blade
height monitor.
Rotary height adjusting switch
Blade height monitor
Checking Cutting Blades
Before starting work, check the cutting blades. Refer to the procedure in "Check and
replacement of cutting blade" shown on page 69.
5314M-0602-030-E
5317M-0502-040-E