Troubleshooting
Area Malfunction Possible cause Corrective action
Engine
Engine does not start * Blade clutch lever is not
in "OFF". (Safety device is
actuated.)
→ Put the lever to "OFF".
* Brake pedal is not depressed.
(Safety device is working.)
→ Depress brake pedal.
* Battery is over-discharged. → Charge battery.
(See page 65)
→ Replace battery.
(See page 66)
* Battery cable is disconnected. → Connect cable.
* Fuse is blown. → Replace.
* Open circuit or contact failure
of wiring
→ Repair. (Consult dealer.)
Difficulty starting * Lack of fuel → Add. (See page 18)
* Air or water in fuel → Check pipe and tightening
band. Repair or replace.
* Excessive intake of fuel → Start after interval.
* Engine oil too low or poor
quality (High oil viscosity)
→ Add or replace.
(See page 49)
* Poor ignition due to dirt on
spark plug or poor sparking
→
Clean or replace. (See page 53)
* Insufficient capacity of battery
(Poor electric starting)
→ Replenish battery fluid.
→ Charge battery.
(See page 65)
* Impurities in fuel circuit → Replace the fuel filter.
(Consult dealer.)
Engine stalls soon
* Lack of fuel → Add. (See page 18)
Engine stops abruptly
* No fuel → Add. (See page 18)
* Burn due to insufficient or dete-
riorated engine oil
→ Check and add oil.
(See page 49)
Improper idling
(lrregular engine speed)
-
→ Ask dealer for service.
Poor power or acceleration
* V-belt loosened → Adjust.
* Improper accelerator adjustment → Ask dealer for service.
* Clogging of air cleaner → Clean or replace.
(See pages 52)
* Stop using machine immediately after any malfunction or abnormal operation occurs. Use
troubleshooting chart (below) to identify problems and corrective actions. Please contact
dealer or CHIKUSUI CANYCOM service center for problems not listed in chart.
* Contact dealer or CHIKUSUI CANYCOM service center for service requiring special tools
or knowledge.
Troubleshooting
To Next Page
Loading...
