CanyCom S25A - Page 75

Troubleshooting
-66-
6
Area Malfunction Possible Cause Corrective Measure Ref.
Engine
Engine overheats
Insufficient amount of
engine oil.
→Fill oil. Page 42
Insufficient amount of
coolant.
→Fill coolant. Page 45
Cooling fan is clogged
or blocked.
→Clean.
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Excessive fuel
consumption
Clogged air cleaner. →Clean or replace air
cleaner.
Page 44
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Black smoke comes
out of exhaust
Bad fuel. →Change fuel.
Clogged air cleaner. →Clean or replace air
cleaner.
Page 44
Other (other than the
above).
→Please contact
your CANYCOM
representative.
White or blue smoke
comes out of exhaust
Engine oil level is too
high.
→Adjust the oil level.
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Accelerator lever does
not move smoothly
Deformed or rusty
linkage or wire.
→Please contact
your CANYCOM
representative.Other (other than the
above).
Drive
Train
Machine does not
move (forward,
backward, turning)
when the control stick
is in the corresponding
position.
Parking brake is
applied
→Release parking
brake.
Page 25
Excessive load →Reduce load.
Insufficient or
deteriorated HST fluid.
→Add or change fluid. Page 52
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Irregular noise or
heat is observed at or
around the track.
→Please contact
your CANYCOM
representative.