3-12 9G3886_en 2011-03-31
Maintenance and Troubleshooting
178 21178 Rollback Failed to Leave
Home
If the Pause symbol is on, press it to cover the film cartridge.
When the Pause symbol stops flashing, remove the film
cartridge from the laser imager. Insert a different film cartridge
into the laser imager.
If the error persists, call for service.
624 21624 Film Supply: Film
Calibration Failure
Calibrate again. See “Calibrating the laser imager for the
installed film” on page 2-9.
If the error still displays, install a new film cartridge.
If the error still displays, restart the laser imager. See page 2-4.
If the error persists, call for service.
631 21631 Film Supply: Film
Calibration Failure - Dmin
Outside Target
The minimum density of the film is too high. Calibration results
for this film are outside the normal range. Printing will continue
with these parameters.
If the prints are not optimal, do the calibration procedure again
(see page 2-9) or install another film cartridge.
632 21632 Film Supply: Film
Calibration Failure - Dmax
Outside Target
The maximum density of the film is lower than the target density.
Calibration results for this film are outside the normal range.
Printing will continue with these parameters.
If the prints are not optimal, do the calibration procedure again
(see page 2-9) or install another film cartridge.
922 25922 RF Tag: Internal Diagnostic
Failure
Restart the laser imager. See page 2-4.
If the error persists, call for service.
323 26323 Film Jam in Area 2 See “Film jam code 323 / Jam in Area 2” on page 3-16.
324 26324 Film Jam in Area 2 See “Film jam code 324 or 325 / Jam in Area 2” on page 3-16.
325 26325 Film Jam in Area 2 See “Film jam code 324 or 325 / Jam in Area 2” on page 3-16.
326 26326 Film Jam in Area 2 or 3 See “Film jam code 326 / Jam in Area 2 or 3” on page 3-17.
543 26543 Film Jam in Area 3 See “Film jam code 543 / Jam in Area 3” on page 3-18.
544 26544 Film Jam in Area 3 See “Film jam code 544 / Jam in Area 3” on page 3-18.
123 27123 Optics: Internal Hardware
Failure
Restart the laser imager. See page 2-4.
If the error pe
rsists, call for service.
601 27601 Optics: Calibration Failed Restart the laser imager. See page 2-4.
If the error persists, call for service.
604 27604 Optics: Calibration Failed Restart the laser imager. See page 2-4.
If the error persists, call for service.
Display
Screen
Web
Portal
Web Portal
Message
Action
To Next Page
Loading...
