To Next Page
C
chavezwilliamAug 4, 2025
What to do if CARLO GAVAZZI Inverter Drive motor can't run?
- CChelsea LeAug 4, 2025
If the CARLO GAVAZZI Inverter Drive motor cannot run, verify that the power is applied to the correct L1, L2, and L3 terminals and that the charging indicator is lit. If not, turn the power OFF and then ON again, ensure the power voltage is correct, and make sure all screws are secured firmly. Also, check if there is voltage across the output terminals T1, T2, and T3; if not, turn the power OFF and then ON again. Check if an overload is causing the motor to stall, and if so, reduce the load. Finally, check for any abnormalities in the inverter by reviewing the error descriptions to check wiring and correct if necessary. You can also try operating the drive through the digital keypad.
General