Carlson Rugged Tablet RT4 - Wi-Fi Wireless Networking

Page | 19
Carlson Software
DRAFT
Wi-Fi Wireless
Networking
3. Make Bluetooth discoverable on both devices. Bluetooth on the RT4
is o by default. To acvate it, open the Acon Center and press and
hold the Bluetooth icon. Select Go to sengs.
4. In the Bluetooth sengs screen, you should see a list of all Bluetooth
devices within range. Tap on the name of the device in the list you
would like to pair with, then tap Pair. If prompted, enter the PIN or
pass code of the paired device. You should now be paired with the
device.
Note: If Bluetooth is on and the tablet enters sleep or hibernate mode,
Bluetooth turns o to save baery power. The connecon is resumed once
it powers back on.
The RT4 has built-in Wi-Fi wireless networking to connect to the internet or
an oce network.
Connecng to a Wi-Fi Network
To use Wi-Fi, you need to be in range of a Wi-Fi access point to make a
connecon. When Wi-Fi is turned on (the default), the RT4 automacally
starts scanning the area for available Wi-Fi networks.
From the Acon Center, click and hold the Wi-Fi network icon, then select
go to sengs. A list of available networks is shown. Select the network you
want to use and enter the network security key. The RT4 remembers the
Wi-Fi network connecons created.
Wi-Fi can be turned o and on and sengs can be managed from this set
up screen.