Carlson Rugged Tablet RT4 - Storing the RT4 and Battery Pack; Protecting the Touchscreen

44 | Page
Carlson RT4 User Manual
Storing the RT4 and Baery Pack
Storing the RT4
and Baery Pack
When the tablet is not being charged and is in a sleep state, it draws a
small amount of power. This power draw is used to maintain the memory
(RAM) of the tablet in the same state it was in when it was awake. We
recommend charging the tablet each night or weekend when it is in a sleep
state.
If the RT4 is not charged while in a sleep state and the baery reaches a
low charge, it automacally hibernates to prevent further drain on the
baery.
Note: Data and programs are secure as long as they have been saved, even
if the baery pack becomes discharged. The tablet does not depend on the
baery to store the data for extended periods.
Storing the RT4 for More than Two Weeks
To store the tablet for two weeks or more, complete the following steps:
1. Charge the baery pack 30 to 50 percent.
2. Close all running programs, and turn o the tablet.
3. Remove the baery pack.
4. If you have an internal baery pack, press and hold the power buon
for 20 seconds to disconnect it.
5. Place the baery pack in a cool, dry locaon.
6. The AC wall charger must be plugged in and connected to the RT4 in
order to turn it on aer storage.
Protecng the Touchscreen
Protect the touchscreen from impact, pressure, or abrasive substances
that could damage it. To further protect the touchscreen, apply a screen
protector (oponal accessory)using the direcons that come with it in the
package.
CAUTION: Be sure to replace the screen protector as oen as the screen
protector instrucons recommend.
Protecng the
Touchscreen