Page | 45
Carlson Software
Cleaning the RT4
Cleaning the RT4 Make sure the baery door is securely installed. Remove the screen
protector if you want to clean underneath it. Use warm water, a mild
cleaning soluon, and a so bristle brush to gently clean the RT4.
CAUTION: Do not direct a high-pressure stream of water at the device to
clean it. This acon could break the seal, causing water to get inside the
device and voiding the warranty.
CAUTION: Exposure to some cleaning soluons may damage your device,
including automove brake cleaner, isopropyl alcohol, carburetor cleaner,
and similar soluons. If you are uncertain about the strength or eect of
a cleaner, apply a small amount to a less visible locaon as a test. If any
visual change becomes apparent, promptly rinse and wash with a known
mild cleaning soluon or with water.
Recycling the RT4 and Baeries
When the RT4 and Li-Ion baery packs for your RT4 reach the end of
their service life, they must not be disposed of with municipal waste. It is
your responsibility to dispose of your waste equipment by handing it over
to a designated collecon point for the recycling of waste electrical and
electronic equipment.
Recycling the RT4
and Baeries