Carpenter Model 860 Material Coiling Unit
Carpenter Model 860 Material Coiling Unit • Phone: (315) 682-9176 • Fax: (315) 682-9160
Website: www.carpentermfg.com • Email: wire@carpentermfg.com
Revised 05/09/2024 Page 18
Normal Operation Mode, Carpenter/Full Auto Control Mode
When operating the Model 860 with any Carpenter Mfg. Co., Inc. material processing machine,
press the NORMAL OPERATION button under “OPERATING MODE”, and press the
CARPENTER/FULL AUTO button under “CONTROL MODE”.
When the Model 860 and the material processing machine are electronically interfaced, each
cycle will be controlled by the material processing machine.
When processing with a Carpenter material processing machine, use of the Carpenter/Full
Auto control mode is recommended.
To Next Page
Loading...