Carrier Klarwind - Remote Control Operations

Carrier Standing Type Inverter Air Conditioner
Fan speed button (Remote control)
● Press the button to select the desired fan speed.
Normal,
Fan mode,
UNIT OPERATION
16
1
2
3
4
5
6
ON/OFF button (Remote control)
● Press the button.
● During the initial operation, the operation mode is set to AUTO, the tempetature is
set to 25℃, and the fan speed is set to auto.
● If you want to change the mode, follow these steps.
Mode button (Remote control)
● Press the button to select the desired operation.
Swing button (Remote control)
● Press the button to control the desired air flow direction to the left and right side.
● Press the button to control the desired air flow direction up and down.
Temperature button (Remote control)
● Press the button to set the desired temperature. (It changes by 1℃)
For heat pump model,
● You can adjust the brightness of the display to prevent disturbances at night.
● Press the button of the remote control to select. (2 steps)
ON/OFF button (Remote control)
●Press the button to stop.
AUTO mode Refer to the AUTO operation method.
Normal mode 17℃ ~ 30 ℃
FAN mode Cannot control.
Controlling the brightness of the display
(AUTO)
(COOL) (DRY)
HIGH
HIGH
LOW
LOW
AUTO Natural Wind
(FAN)
For cooling only model,
(AUTO)
(COOL) (DRY) (FAN)(HEAT)