User / Install Manual
MAINTENANCE
● You must turn off the unit before you clean the anti-fungus filter.
● Clean it once every other week depending on the level of air pollution and the amount of
hours the unit is in use.
● When you reassemble after cleaning, correctly fit the groove of the anti-fungus filter into
the air inlet. (Otherwise, the unit will not operate properly.)
● The ifD filter can be used semipermanently, though you need to clean it once a year if
the air is severely polluted.
● It is fixed firmly for your safety so that it cannot be separated from the outside. When
cleaning is necessary, call your local dealer.
Cleaning the anti-fungus filter
Cleaning the ifD filter
Press the snap-fits of
the anti-fungus filter
assembled to the back
side of the unit in the
direction of 1 or 2 and
separate it.
Insert the filter. Place the fixing snap fits on the opposite side and then insert the
rest of them. (there are two on each side (left/right) and you can start fixing them
on either side)
Dry filter completely
in a place away from
direct sunshine.
1
4
2 3
Use a vacuum cleaner
or tap water to clean the
filter. If there is a lot of
dust, use a neutral agent
or soapy water. (Using
a brush could lower
performance)
27
Vacuum
cleaner,
Tap water
To Next Page
Loading...
