Carrier Standing Type Inverter Air Conditioner
●
The product should be installed by people who are authorized by the service center or the main office.
● The product is only used at 220V, and you must use the special AC circuit for the power supply.
● Before installing the unit, check the following parts.
The following field supplied items are required to complete the installation.
The following accessories are supplied with unit. Use them as required.
Parts
30
CHECK BEFORE INSTALLATION
Part Name Specification
Connection pipe
Diameter 12.7mm (Gas)
Connection wire
Drain hose
Finishing tape
Pipe insulation
H07RN-F 1.5SQ X 4G
Diameter 6.35mm (Liquid)
Q'tyName
1
1
4
For remote control installation
Mounting bracket
for remote control
Wood screw
Wire nut connector
Use
For mounting bracket installation
For fastening two connection wires together
Part Name Specification
Connection pipe
Diameter 12.7mm (Gas)
Connection wire
Drain hose
Finishing tape
Pipe insulation
H07RN-F 1.5SQ X 4G
Diameter 6.35mm (Liquid)
Q'tyName
1
1
4
For remote control installation
Mounting bracket
for remote control
Wood screw
Wire nut connector
Use
For mounting bracket installation
For fastening two connection wires together
To Next Page
Loading...
