Carrier RG2059 Series - Page 21

2–9 T-361
Series Attempt Number 3 Engine Status:
If the engine starts:
1. Run sequence begins.
If the engine fails to start:
1. Intake heater will de-energize.
2. Fuel solenoid will de-energize.
3. Crank output will de-energize.
4. Overcrank LED will flash three times. Wait two seconds and
repeat.
5. Unit will rest five hours and proceed to the next series.
Intake Heater Energized
in Seconds
30
Fuel Solenoid Engaged X
Engine Crank Duration
(Seconds)
Up to 15
Engine Rest Duration
(Seconds)
25
Series Attempt Number 4 Engine Status:
If the engine starts:
1. Run sequence begins.
If the engine fails to start:
1. Intake heater will de-energize.
2. Fuel solenoid will de-energize.
3. Crank output will de-energize.
4. Overcrank LED will flash four times. Wait two seconds and repeat.
5. Unit will rest five hours and proceed to the next series.
Intake Heater Energized
in Seconds
30
Fuel Solenoid Engaged X
Engine Crank Duration
(Seconds)
Up to 15
Engine Rest Duration
(Seconds)
25
Series Attempt Number 5 Engine Status:
If the engine starts:
1. Run sequence begins.
If the engine fails to start:
1. Intake heater will de-energize.
2. Fuel solenoid will de-energize.
3. Crank output will de-energize.
4. Overcrank LED will flash five times. Wait two seconds and repeat.
5. Unit will rest five hours and proceed to the next series.
Intake Heater Energized
in Seconds
30
Fuel Solenoid Engaged X
Engine Crank Duration
(Seconds)
Up to 15
Engine Rest Duration
(Seconds)
25
Series Attempt Number 6 Engine Status:
If the engine starts:
1. Run sequence begins.
If the engine fails to start:
1. Intake heater will de-energize.
2. Fuel solenoid will de-energize.
3. Crank output will de-energize.
4. Overcrank LED will illuminate solid and lock out future crank
attempts.
5. To reset, turn unit power switch OFF and back ON..
Intake Heater Energized
in Seconds
30
Fuel Solenoid Engaged X
Engine Crank Duration
(Seconds)
Up to 15
Engine Rest Duration
(Seconds)
25
Table 2–3 Auto Restart Sequencing (Continued)