5–15 T-361
Figure 5.15 Engine Shockmounts
5.8 UNIDRIVE TORQUE REQUIREMENTS
Extensive damage may occur if the proper hardware is not used and/or proper procedures are not followed when
working with the unidrive assembly. Periodic inspection of hardware and bolt torque is recommended to ensure the
integrity of the unidrive.
Torque value and hardware requirements for unidrive assembly are provided in Figure 5.17.
Screw (5/8)
Lock Washer (5/8)
Flat Washer (5/8)
Snubbing Washer
Shockmount
FRAME
ENGINE
To Next Page
Loading...
