T-361 5–14
When a shockmount has been cut, split, abraded or has flared due to normal deterioration, it must be replaced.
Damage to the mounts may not be visible when installed and under load from the component. To correctly inspect
shockmounts, they must be removed.
Engine Shockmount Replacement
NOTE
Refer to Section 5.8 for torque values.
1. Use the two lift eyes to lift and support the engine.
2. Remove snubber hardware as shown in Figure 5.14.
3. Remove all hardware as shown in Figure 5.15.
4. Raise the engine just enough to remove the shockmounts.
5. Inspect shockmounts and replace if required.
6. Lower the engine enough to assemble hardware as shown and torque per Section 5.8.
7. Replace snubber hardware as shown in Figure 5.14.
8. Remove chains from the lift eyes.
Generator Shockmount Replacement
1. Use the two lift eyes to lift and support the engine.
2. Remove snubber hardware as shown in Figure 5.14.
3. Remove shockmount hardware, Figure 5.16.
4. Raise the generator just enough to remove the shockmounts.
5. Inspect and if required, install new shockmounts.
6. Lower the engine enough to assemble hardware as shown and torque. Refer to Figure 5.8 for torque values.
7. Replace snubber hardware as shown in Figure 5.14.
8. Remove chains from the lift eyes.
Figure 5.14 Snubber Hardware
Washer (1/2)
Lock-nut (1/2-3)
Bracket Assembly
Hexhead Screw
(1/2-13 x 3.50)
Washer, Special
Snubber
Washer, Flat
To Next Page
Loading...
