Carrier RG2059 Series - Figure 5.17 Unidrive Torque Requirements

5–17 T-361
Figure 5.17 Unidrive Torque Requirements
ENGINE & GENERATOR
SHOCKMOUNTS
ENGINE MOUNT
5/8-11 x 4.00lg - SST
92.5 + 9.2 ft-lb (125.41Nm)
5/8-18 x 2.25 lg - SST
92.5 +
9.2 ft.-lb (125.41Nm)
1/2-13 x 3 lg - SST
75 + 9.4 ft.-lb (101.69Nm)
3/8-16 x 1-1/4 lg - SST
31 +
3.7 ft.-lb (42.03Nm)
UNIDRIVE
M8 x 25MM lg - SST
19 + 2 ft.-lb (25.76Nm)
3/8-16 x 1.75 lg - SAE 5
(6 Req’d) 30 ft-lb +
3 ft-lb
(40.67Nm)*
* After torquing mark each with a
permanent marker and bend tabs
Generator Disc Drive
Engine Flywheel