iii
62−11389
TABLE OF CONTENTS − Continued
PARAGRAPH NUMBER Page
3.18 STOPPING UNIT 3−29.....................................................................
3.19 DataLink DATA RECORDER 3−30...........................................................
3.19.1 Microprocessor Information 3−30.........................................................
3.19.2 Data Recording 3−30...................................................................
3.19.3 Data Downloading 3−30.................................................................
3.19.4 DataLink Data Recorder Power-Up 3−30..................................................
3.20 OPTIONS 3−31...........................................................................
3.20.1 DataTrak 3−31.........................................................................
3.20.2 Remote Control Panel 3−32..............................................................
a.Starting Unit with Remote Control Panel 3−33.............................................
b. Changing Set Point With Remote Control Panel 3−33......................................
c.Lock / Unlock the Remote Control Panel 3−34.............................................
d. Pre-setting Set Point With Remote Control Panel 3−34....................................
e. Removing Pre-Set Set Points With Remote Control Panel 3−35.............................
ENGINE/STANDBY/TEMPERATURE CONTROL 4−1.................................................
4.1 INTRODUCTION 4−1.....................................................................
4.2 ENGINE/STANDBY OPERATION 4−1.......................................................
4.2.1 Standby Start-Up 4−1..................................................................
4.2.2 Engine Start-Up 4−1...................................................................
4.2.3 Transition To High Speed 4−2...........................................................
4.3 TEMPERATURE CONTROL 4−2...........................................................
4.3.1 Temperature Determination 4−2.........................................................
4.3.2 Perishable And Frozen Set Point Ranges. 4−3............................................
4.3.3 Pull Down/Pull-Up 4−3.................................................................
4.3.4. Defrost 4−3..........................................................................
4.3.5. Overrides 4−3........................................................................
4.4 START-STOP OPERATION 4−3............................................................
4.4.1 Start-Stop Configuration 4−3............................................................
4.4.2 Stop Parameters 4−4..................................................................
1. It has run for the selected Minimum Run Time 4−4......................................
2. The engine coolant temperature has warmed 4−4.......................................
3. The battery is fully charged - Voltage 4−4..............................................
4. The battery is fully charged - Amperage 4−4............................................
5. The compartment temperature requirement is satisfied 4−4...............................
4.4.3 Re-Start Parameters 4−5...............................................................
1. Engine coolant temperature drops below selected microprocessor Configuration value 4−5...
2. Battery voltage falls below selected microprocessor Configuration value 4−5................
3. The Maximum Off Time has expired 4−5...............................................
4. The Minimum Off Time has expired 4−5................................................
5. Compartment temperature has exceeded the Override Functional Parameter value 4−5......
4.5 CONTINUOUS OPERATION 4−5...........................................................
4.5.1. Introduction 4−5......................................................................
4.5.2. Continuous Operation 4−5..............................................................
To Next Page