Carrier VECTOR 6500 - Page 6

iv
62−11389
TABLE OF CONTENTS − Continued
PARAGRAPH NUMBER Page
4.6 DEFROST 4−8...........................................................................
4.6.1 Defrost Initiation And Start 4−8...........................................................
a. Defrost based on coil condition 4−8....................................................
b. Defrost based on time: 4−8...........................................................
4.6.2 Defrost Modes 4−8.....................................................................
a. Normal Defrost Mode 4−8............................................................
b. Natural Defrost Mode 4−8............................................................
4.6.3 Defrost Termination 4−8.................................................................
4.7. USER SELECTED OVERRIDE OPERATION 4−9.............................................
4.7.1 Supply Air Limit Control 4−9............................................................
4.7.2 Temperature Range Lock 1 & 2 4−10.....................................................
4.7.3 ProductShield 4−11.....................................................................
4.8. PREPROGRAMMED SOFTWARE OVERRIDES. 4−13.........................................
4.8.1 Cargo Protect Mode. 4−13..............................................................
4.8.2 Compressor Minimum Operating Time 4−13...............................................
4.8.3 Engine Speed Overrides 4−13...........................................................
4.8.4 Unloader Control Overrides 4−14.........................................................
4.8.5 Defrost Safety Override 4−16............................................................
MICROPROCESSOR INTERFACE 5−1..............................................................
5.1 INTERFACE METHODS 5−1...............................................................
5.2 TECHNICIAN INTERFACE 5−1............................................................
5.2.1 Configuration Mode 5−2................................................................
5.2.2 Component Test Mode 5−2.............................................................
5.2.3 Service Mode 5−3.....................................................................
5.3 PC MODE 5−3...........................................................................
5.4 PC CARDS 5−4..........................................................................
5.4.1 Handling PC Cards 5−4................................................................
5.4.2 Program PC Card 5−5.................................................................
5.4.3 Configuration PC Card 5−6.............................................................
5.4.4 Option PC Card 5−6...................................................................
5.4.5 Download PC Card 5−6................................................................
5.5 REEFERMANAGER & REPORTS 5−6......................................................
5.5.1 Introduction 5−6......................................................................
a. ReeferManager 5−7.................................................................
b. Reports 5−7........................................................................
c. Connecting Computer and Microprocessor: 5−7.........................................
5.6 MICROPROCESSOR DISPLAY DIAGNOSTICS 5−8..........................................
5.7 MICROPROCESSOR REPLACEMENT & SETUP 5−8........................................
5.7.1 Pre-Replacement Steps 5−9............................................................
5.7.2 Microprocessor Replacement 5−9.......................................................
5.7.3 Microprocessor Setup 5−10..............................................................
5.7.4 Configurations Via Keypad 5−11.........................................................
5.7.5 Functional Parameters Via Keypad 5−11..................................................
5.7.6 DataLink Data Recorder Via ReeferManager 5−11..........................................
5.7.7 Microprocessor Final Checkout 5−11.....................................................