`
1
■ How-to-use the Keys
Function Key
Not supported in CI-505A
* Sets the weight near zero to be displayed as 0.
(select range from 2%, 5%, 10%, 20%, 100%)
Not supported in CI-505A
*Use this key to measure the weight using a container.
*When this key is pressed, the scale stores a current weight as
the tare.
*To clear this function, press this key when the scale is cleared
of any weight.
Not supported in CI-505A
*After setting the tare, press this button to alternate from gross
to net weight.
(When the net weight lamp is on, the displayed weight is the
net weight, and when the net weight lamp is off, the displayed
weight is the gross weight.)
Not supported in CI-505A
*Used to print manually.
*Used to indicate the maximum value of the changes in weight
(Peak-Hole), the value at the moment (Sample-Hold) or the
average weight (Average Hold).
*Used to clear the hold function.
*Some functions may be assigned according to the purpose of
utilization.
(Set the purpose of utilization in number F16)
*Some functions may be assigned according to the purpose of
utilization.
(Set the purpose of utilization at number F17)
To Next Page
Loading...
