`
16
* Used to register an ID number. (1~99)
* Used to save and/or clear the current status in the calibration mode,
set mode, and test mode
Double Key
(*After pressing the step (#6 Key) or set key, enter the number key)
* Used to check and/or change the weight of Step1.
* Used to check and/or change the weight of Step2
* Used to check and/or change the weight of Step3
* When F-51 is set to 2 or 4, it is used as Step1- Free Fall.
* Used to check and/or change the weight of Step4
* When F-51 is set to 2 or 4, it is used as Step2-Free Fall.
* Used to check and/or change the lowest limit error value
(Low NG)
* Used to check and/or change the upper limit error value
(High NG)
* Used as a Tare key
* When the tare is known, it is used to directly input the
tare(the weight of container).
To Next Page
Loading...
