152
3.4 Calling Up a PLU
There are two ways to call up a PLU by using numeric key and preset key. (speed key)
3.4.1 Using Numeric Key
① Enter PLU number by using numeric keys and
press “PLU” key.
EX) PLU No. 15
Note: Even if the operator does not press the PLU Key after entering a PLU Number,
the PLU will still be displayed depending on the setting time in Parameter 586 (Indirect
PLU Call Time). If the setting time is set to 0 the operator must press the PLU Key to
recall the PLU.
3.4.2 Using Speed Key
To use a Speed Key to call up a PLU, the PLU must already be assigned to that Speed
Key. To call up a PLU using a Speed Key simply press the appropriate Speed Key that
is attached to the PLU you want to recall.
Note: Speed Keys must be programmed using Menu 1160 (Chapter 2.6)
① Press a speed key (which is save as a PLU).
EX) PLU #79=Apple, Speed key #5
To Next Page
Loading...
