79
2.6 Speed Key Setting
2.6.1 Speed Key Setting (Menu code 1160)
( MENU → 1. PLU → 6. SPEED KEY )
This menu is used to program Speed keys. Speed keys are short-cut keys used to allow
quick access to the most frequently used PLU's in a department. There is also a SHIFT
function that allows you to set a second level of Speed keys that will double the number
of Speed keys available in a department.
You can program up to 5 different Speed Key Sets but only one set can be used in a
department at a time. The Speed Key Set that is used in a department is determined by
Menu code 1211 (chapter 2.2.2)
Note: Function keys can be programmed using Menu code 1880 (chapter 2.14.22) and
are assigned to Speed Key locations. If you program Function keys on the CL5000 you
will decrease the total number of Speed Keys available.
1. Speed Key Set No.
• Select speed key set no. You can use this
number when you program menu 1211.
(See the chapter 2.2.2)
EX) Speed key set No. = 2
2. Speed Key Programming
• The Speed Keys are numbered left to right
and top to bottom. Standard keyboard type
has 48 physical keys but by using the SHIFT
function you can have up to 96. The CL5000
Pole type has 72 physical keys but can have
a maximum of 144 by using the SHIFT
function.
EX1) Speed key no. 1
or
EX2) Speed key no. 49
Note: In Ex. 2, by using the RETURN/SHIFT
key, the same physical key can be
programmed to recall two different PLU's.
To Next Page
Loading...
Need help?
General
