42
2.1.3 Create By-Count PLU (Menu code 1120)
( MENU → 1. PLU → 2. New/Edit )
※ Not all programmable PLU Items are shown in this example.
By-PCS PLU is used depending on the Parameter 593.
◆ You can press the SAVE key at anytime to save the current PLU data
and if you want to exit without saving, press the ESC key.
1. Enter Department No. / PLU No.
• Department should be set previously.
EX) Department # = 1. Default
PLU # = 3
2. Select PLU Type
1. By Weight
2. Non Weight
3. By By Count
EX) By-Count Item
3. Enter PLU Name1
EX) CAKE
4. Pieces
• If you enter 0 , it is regarded as 1.
EX) 10 piece
5. Qty Descriptor No.
• This is the place where you select what
Descriptor will print on the label.
ex., PCS, QTY, EACH, etc.
EX) Qty Unit No. 6
To Next Page
Loading...
