150
OTHER RECORDING FUNCTIONS
Before Using an External Flash Unit
Be sure to perform the following steps before using an
external flash unit.
1.
In a REC mode, press [MENU].
2.
Select the “REC” tab, select “External flash”,
and then press [].
3.
Use [] and [] to select “On”, and then
press [SET].
To do this:
Enables firing of an external flash.
Disables firing of an external flash.
Select this setting:
On
Off
IMPORTANT!
• Note that the brightness of what you see on the
monitor screen will be different from the brightness of
the image you record. Make sure you check the
settings of your external flash and of the camera
before recording.
• Turning the camera’s external flash setting on and
off not only determines whether or not a connected
external flash fires, it also changes the setup of the
camera. Make sure you always turn the external
flash setting off whenever you are not using an
external flash unit for recording.
To Next Page
Loading...
Need help?
General
