76
BASIC IMAGE RECORDING
• With the Triple Self-timer, the camera records a series
of three images in the sequence described below.
1. The camera performs a 10-second countdown
and then records the first image.
2. The camera prepares to record the next image.
The amount of time required for preparation
depends on the camera’s current “Size” and
“Quality” settings, the type of memory (built-in or
card) you are using for image storage, and
whether or not the flash is charging.
To do this:
Disable the self-timer
Specify a 10-second self-timer
Specify a 2-second self-timer
Specify Triple Self-timer
Specify self-timer off for remote
controller operation (page 146)
Specify 2-second self-timer for remote
controller operation (page 146)
Select this setting:
No icon displayed
10
s
2
s
x3
2s
3. After preparation is complete, the indicator “1sec”
appears on the monitor screen, and another
image is recorded one second later.
4. Steps 2 and 3 are repeated once more to record
the third image.
2.
Record the image.
• When you press the
shutter button, the self-
timer lamp flashes as
the countdown
progresses, and then
the shutter releases
after the self-timer
reaches the end of its
countdown.
• You can interrupt an
ongoing self-timer
countdown by pressing
the shutter button while
the self-timer lamp is
flashing.
Self-timer lamp
To Next Page
Loading...
Need help?
General
