Reference
EN-191
Compressor Compresses the input signal and suppresses level variation.
Attack Attack Adjusts the time until compression goes into
effect. A smaller value causes prompt
compressor operation, which suppresses the
attack of the input signal. A larger values delays
compressor operation, which causes the attack
of the input signal to be output as-is.
000 - 127
Release Release Adjusts the time until compression is released
after the input signal drops below a prescribed
level. When an attack feeling is desired (no
compression at the onset of the sound), set this
parameter to as low a value as possible. To
have compression applied at all times, set a
high value.
000 - 127
Ratio Ratio Adjusts the compression ratio of the audio
signal.
1:1, 2:1, 4:1,
8:1, 16:1, 32:1,
Inf:1
Wet Level Wet Level Adjusts the level of the effect sound. Output
volume changes in accordance with the Ratio
setting and the characteristics of the input tone.
000 - 127
Dry Level Dry Level Adjusts the level of the direct sound. 000 - 127
Limiter Limits the input signal level so it does not rise above a preset
level.
Limit Limit Adjusts the volume level of the limit at which
limiting is applied.
000 - 127
Attack Attack Adjusts the time until the compression effect
starts. A smaller value causes prompt limiter
operation, which suppresses the attack of the
input signal. A larger values delays limiter
operation, which causes the attack of the input
signal to be output as-is.
000 - 127
Release Release Adjusts the time until compression is released
after the input signal drops below a prescribed
level.
000 - 127
Wet Level Wet Level Adjusts the level of the effect sound. Output
volume changes in accordance with the Limit
setting and the characteristics of the input tone.
Use this parameter to correct for such changes.
000 - 127
Dry Level Dry Level Adjusts the level of the direct sound. 000 - 127
Effect
Description Settings
Display
Parameter
Name
To Next Page
Loading...
Need help?
General
