Changing the Sound During a Performance
EN-74
■ List of Assignable Functions to the Knobs
Function Category
*1
Description
Cutoff Freq. Knob/CTRL Adjusts timbre by attenuating the components of a note’s
frequency characteristics that are higher than a certain
frequency (cutoff frequency). A larger value specifies a
brighter, harder sound, while a lower value specifies a
mellower, softer sound.
Resonance Knob/CTRL Adjusts the degree to which the gain of the overtone
component is increased near the frequency specified by
“Cutoff Freq.” above. A larger value specifies a more unusual
sound.
Modulation Knob/CTRL Adjusts the level of the modulation effect.
Brilliance Effect Adjusts the brightness of a sound.
Hall/Rev. Send Mixer Adjusts the send value to the Hall Simulator/Reverb for the
Upper 1 part.
Chorus Send Mixer Adjusts the send value to the chorus for the Upper 1 part.
Attack Time Knob/CTRL Adjusts the time after a key is pressed from when the note
starts to sound until it reaches maximum volume. A larger
value specifies a slower attack.
Release Time Knob/CTRL Adjusts how long notes linger after keyboard keys are
released. A larger value specifies a longer release.
Vibrato Rate Knob/CTRL Adjusts the speed of vibrato of a tone.
Vibrato Depth Knob/CTRL Specifies the depth of vibrato of a tone.
Delay Vib Time Knob/CTRL Adjusts the time until the vibrato of the tone starts after a
note is sounded.
Portamento Time Tone Adjusts the duration of the portamento notes.
Layer Balance Mixer Adjusts the Upper 1 part and Upper 2 part volume level
balance.
Upper1 Pan Mixer Adjusts the stereo pan of the Upper 1 part.
Upper2 Fine Tune Tone Adjusts the part fine tune of the Upper 2 part.
AR
Key press
Key release
Note End
Time
A: Attack Time
R: Release Time
Note Volume
To Next Page
Loading...
