Casio TE-2400 Service Manual

— 34 —
[ 4 ] RAM READ ONLY test
[Function]
RAM READ ONLY test is performed.
Perform the WRITE test (n011) right before start of this test.
System area test for COMMON is not performed.
[Operation]
Operation : n 1 1 1 SUBTOTAL
n : 0 = One time check (can be omitted)
not 0 = Continuous check ( Press the “C” key or turn off the power by rotating the key to
end the test.)
[Pop-up display]
A counter is displayed for Pop-up display.
Address of an error is printed if the test ended with an error.
n=0  1  2  3
[Main display]
n
DIAG 0111
00n
n=0  1  2  3
[Print]
The result for all area test for RAM is printed as follows.
* Refer to RAM WRITE/READ test when NG is printed.
RAM 11 1
RAM RD OK
END 1 1 1
[ 5 ] CF-CARD WRITE/READ test
[Function]
This test will check the write/read test (connection test) for CF-CARD.
Perform the CF-CARD clear test, before start of this test.
Note that this test does not ensure the data inside the CF-CARD as well as its performance.
[Operation]
Operation : 0 n 0 1 3 SUBTOTAL
n : 0 = One time check( can be omitted)
not 0 = Continuous check (To stop the test, press “C” key or turn off the power by rotating
the key.)
[PRINT]
NG and the address are printed if WRITE cannot be done
normally.
CF - CARD 13
CF WR OK
END 13

Casio TE-2400 Specifications

General

Types of payment	Cash
Supported paper width	58 mm
Display digits	10 digits
Second display	Yes
Second display type	LED
Display number of characters	16
Power source	AC
AC input voltage	120-230 V
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	450 mm
Width	400 mm
Height	277 mm
Weight	12000 g