- 37 -
13) RAM read only check
This test will check the read only check for RAM.
Perform the RAM check (EX: command "1 and #2 " ), before start of this operation.
Operation : X 5 #2 Key
X: 0= One time check.
1= Continuous check. To stop the test, set the mode switch to OFF.
NOTE: During the RAM test, the Receipt switch LED is blinking.
[PRINT] [DISPLAY]
Segment display
14) RAM read write check
This test will check the read write check for RAM.
Operation : n 4 X 0 #2 Key
X: 0= Automatic RAM capacity detection
1= RAM1 (128K) test only
2= RAM2 (128K) test only
4= RAM3 (512K) test only
6= RAM4 (512K) test only (Do not select for TK-6000.)
NOTE1: RAM1 is always checked even if selected other RAM number.
NOTE2: RAM4 is not used for TK-6000.
[PRINT] [DISPLAY]
Segment display
To Next Page
Loading...
Need help?
General
