Centa CENTAX-L - Application Not in Compliance with the Intended Use

Assembly and operating instructions
CENTAX-L
016L-00050…00090-FS10
M016-00003-EN
Rev. 3
CENTA Antriebe Kirschey GmbH 9 / 46
2.4 Application not in compliance with the intended use
WARNING
Injury and material damage can occur as a result of:
 Inadmissibly high torque
 Inadmissibly high or low speeds
 Exceeding the specified ambient temperature
 Inadmissible ambient medium
 Inadmissible coupling enclosure
 Exceeding the admissible overall misalignment values
Only use the coupling for the specified application.
CENTA bears no liability for damage resulting from application not in compliance
with the intended use of the equipment.
Should there be a change of plant parameters, the coupling design must be
reviewed by CENTA (address see chapter 1).