Cessna T182 Series User Manual

MODEL
182
& T182 SERIES
SERVICE
MANUAL
15
6
28
NOTES
Roll pin (28) must be bonded to shaft (18) with
EA9316, EA9309
or EA9314. These
products may
be purchased
from Hystol Div.
Dexter Corp.,
Willow Pass Rd; Pittsburg, CA 94565. Equivalent
product. EC2216, may be purchased from 3M Co..
St.
Paul, MN 55119. Clean
roll (28) and shaft
(18)
with MEK, and thoroughly dry parts before ap-
plying bonding
agent. At 75°F, bond
cures to 80%
ultimate tensile strength within 24 hours. Accel-
erated cure times
are as follows:
(a) Five minutes at 250°F
(b) Ten minutes at 200°F.
Before
installing screw
(26) on drive shaft
(18),
clean threads of screw (26) with MEK or equiva-
lent. After
threads
have thoroughly
dried,
apply
Grade CV Loctite Catalog 85 or 83, Loctite 242, or
equivalent. Loctite
products may
be obtained
from: Loctite
Corp., 705
Mountain Rd,
Newington. CT 06111.
Figure 12-7. Fuel Selector Valve and Controls (Sheet 3 of 3)
12-21

Cessna T182 Series Specifications

General

Engine Type	Lycoming IO-540-AB1A5
Horsepower	230 hp
Seating Capacity	4
Service Ceiling	18, 100 feet
Takeoff Distance	1, 600 feet
Landing Distance	1, 350 ft
Type	Single-engine
Max Takeoff Weight	3, 100 lb
Wingspan	36 ft
Length	29 ft
Height	9 feet 3 inches
Fuel Capacity	92 US gal (348 L)