2. Hold the System-Master again for ca 1 second in the reading field of the locking device and
then remove it from the reading field.
The following signal appears:
1x long green
The System-Master is now authorised for this locking device.
Troubleshooting:
Signalling Reason Solution
During step 1:
The System-Master does not have the cor-
rect system identification code.
Use the System-Master with correct sys-
tem identification code.
During step 2:
Another System-Master has already been
authorised for this locking device.
Since, at any given time only one
System-Master exists which can
be authorised on the basis of
individual system identification
code for a locking device, there is
reason to suspect manipulation.
Contact your CES partner
immediately!
Page 110 of 141 Long shield ILS
11.1 Authorising System-Master
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration Assembly Basics
To Next Page
Loading...
