4 Assembly
4.1 Important notes on assembly
Risk of injury while working on the punched metal parts.
The electronic handle sets contain punched metal parts, which can have
sharp edges.
- Wear work gloves during the assembly work.
Damage to the handle set is possible if not assembled properly.
The handle set can be damaged if not assembled properly.
- The handle set may only be assembled by competent persons. These
persons must have been trained on the product by CES or a CES partner.
Lock out possible.
The door can slam shut during assembly and you can no longer open the
door.
- Secure the door against slamming shut during assembly.
- Ensure that you have an authorised locking media.
4.2 Preparations for assembly
4.2.1 Check the scope of delivery
1. Remove the fitting from the packaging and remove all packaging materials such as films,
filler material and the packing box.
2. Check the scope of delivery ; see the relevant chapter on the respective handle sets and ver-
sions.
3. Check the new equipment for transport damages and report these to your CESpartner
immediately.
Page 16 of 141 Long shield ILS
4.1 Important notes on assembly
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
