11.10 Deactivating release mode
Required master media:
l Release-Master
The Program-Master must first be authorised for the locking device on which it is to be
used, see "Authorising additional master media" on page111
Procedure:
1. Hold the Release-Master before the reading field of the locking device.
After ca. 2 second, the following signal appears:
2x short green
The release mode is now deactivated. To gain access, authorised locking media must now again be
held before the locking device.
Troubleshooting:
Signalling Reason Solution
A higher-priority opening mode is cur-
rently active (see "Hierarchy of the open-
ing modes" on page84).
Deactivate the
opening mode with higher priority.
The Release-Master is not authorised. Authorise the
Release-Master
Long shield ILS Page123 of 141
11.10 Deactivating release mode
Overview: Master media usage
Help & troubleshooting
Technical data
Maintenance & disposal Operation Administration Assembly Basics
To Next Page
Loading...
