CEStronics CES OMEGA FLEX - Assembling Basic Version (for Long Shield Holes)

4.5 Assembling basic version (for Long shield holes)
4.5.1 Scope of delivery Long shield ILS basic version
1 1 Outside fitting, pre-assembled with outside lever handle, coupling module and e-module
2 1 Assembly plate, pre-assembled with inside lever handle
3 1 Inside shield
4 1 Fixture ring
5 1 Square spindle
6 3 Washers (for fixing screws)
7 3 Locking nuts (for fixing screws)
8 2 Fixing screws without cable slit (with fixing rings)
9 1 Fixing screw with cable slit (with fixing ring)
10 2 Batteries Energizer Ultimate Lithium 1,5V AA
11 1 Battery module
12 1 Support frame
13 1 Spring clip (only for handle sets without a PZ hole)
14 1 Installation tube
4.5.2 Assembling Long shield ILS basic version
The reading side of the fitting is assembled on the outside of the door; the non-reading side is
assembled on the inside.
The handle set cannot be assembled on split follower locks!
Page 20 of 141 Long shield ILS
4.5 Assembling basic version (for Long shield holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics