6 Operation
This chapter is intended for persons who operate the locking devices using locking media.
6.1 Opening doors
6.1.1 Opening the door from the inside.
To operate the handle set from the inside, you do not require any locking media. The door can
always be opened from the inside by operating the lever handle (door handle).
6.1.2 Opening the door from the outside
To operate the handle set from the outside, you require an authorised locking media. Although
without the locking media, the lever handle of the handle set can be pushed down, but the door
cannot be opened.
Do not cover the reading field of the handle set with metallic materials. Otherwise, no
locking media can be read.
Procedure:
1. Hold an authorised locking media for ca. 1 second in the reading field of the locking device
(maximum distance ca. 10 mm).
The following signal appears:
1x short green
You can open the door by pressing the lever handle for a certain period. The length of the time
period depends upon the opening period set.
During the opening period no further locking media or master media are read. Only after
you hear that the coupling of locking device has disengaged, you can hold another locking
media in the reading field of the locking device.
Troubleshooting:
Signalling Reason Solution
The locking
media cannot
The locking media was not held close
enough to the reading field of the locking
Hold the locking media longer in the
reading field of the locking device.
Long shield ILS Page 85 of 141
6.1 Opening doors
Overview: Master media usage Help & troubleshooting Technical data Maintenance & disposal
Operation
Administration Assembly Basics
To Next Page
Loading...
